Do you have a broken or missing Centre console armrest lid? It can make a big difference in the comfort of your car. If so, you may be wondering how to install an aftermarket one. Well, there are just a few simple steps involved.
Step 1 – Remove the original armrest
Before you can install your new aftermarket lid, you need to remove the old one. Start by opening it up fully and locating any hardware inside of it. There may be screws or clips holding the lid in place. If there are, simply remove them with your screwdriver or pliers. Take care not to scratch or otherwise damage anything around them as you do this.
Now that all of the fasteners have been removed, lift gently on each end of your armrest until it starts detaching itself from the console frame. Set it aside carefully for now (you may want to lay down some paper towels under it) so that you don’t damage anything else in there during this step.
Step 2 – Install new armrest lid
Now it’s time to install your new Centre console armrest lid. Start by taking a look at its underside and locating where the clips on each side attach to the frame of the vehicle. Put on some gloves, then use your flathead screwdriver or other small pry implement to pull each clip from its slot on the frame. Be careful not to damage anything while you do this since these poked metal edges can be sharp and can easily scratch the paint if you aren’t careful!
Once all of them have been removed, it should be very easy for you to slide your armrest lid into place against the frame of the car. Pull gently on one end until it starts to slide into place. Once fully inserted, put the clips back in their slots on each side of the armrest. It should snap right into place and hold firmly!
Step 3 – Attach hardware to the lid
Now that your new armrest is installed, you only have one more piece of hardware to attach before it’s ready for use: its lid fastener. Start by looking at where your old one was located and then drill a pilot hole for your new screws or rivets. Make sure that all of them fit snugly here without any gaps left around them. Then, use a screwdriver or drill driver to attach them securely.
That’s all there is to it! You now have a brand-new center console armrest lid where the old one used to be. Try it out and see how much more comfortable your car is now that you have a built-in place to rest your arms while driving.
How to determine if you need a new armrest lid
When it comes to car comfort, a center console armrest lid is a big deal. If your original armrest is broken or missing, you may need to replace it. But how can you be sure?
There are a few things to consider when deciding whether or not you need a new armrest lid. The first is how old your car is. If your car is more than a few years old, the chances are good that the original armrest lid is no longer in good condition. The next thing to consider is how often you use your car. If you drive it every day, the armrest is likely to wear down more quickly than if it’s only used on weekends.
Finally, take a look at the lid itself to see how it’s attached. Most armrest lids have a plastic or metal latch that is attached to the lid with four bolts. If one of those bolts is broken or stripped, you might want to just replace the whole thing entirely to ensure safety and comfort.
Tips for keeping your center console looking good:
1. Use a protectant to keep the surface looking new.
2. Wipe it down regularly with a wet cloth to remove any dirt or debris.
3. Avoid putting heavy items on top of it, as this can cause damage over time.
4. Clean up any spills immediately to avoid staining or discoloration.
5. Be careful when removing or installing cassette tapes because excessive force can damage the lid and buttons.
Conclusion
Installing a new centre console armrest lid is a great way to improve the look and feel of your car’s interior. With a few easy steps, you’ll be on your way to installing it. Be sure to check if you need a new armrest lid before you begin, and follow our tips for keeping your center console looking good.
